Well, while doing checking on drawing, there is one things that i keep on learning but keep on forgetting: that is welding. I'd stumbled upon the fillet weld and bevel joint during the checking. So basically you look into the figure on the left, you have a basic mental idea of the welding drawing practices.
Actually the tail is where reference like the welding or cutting processes, welding specification, procedures, or the supplementary information used in making the weld. So, if you ain't got any information that you would like to present, you can omit the tail. As for the weld side, you can put it beside the symbols of type of weld: below and above the reference line.
No comments:
Post a Comment